How to use

Installation Procedure

*Please be sure to remove any hair before wearing.
By following these steps, you can easily wear your prosthesis.

1. A special adhesive is applied to the area where the prosthesis will be attached.

2. Press the prosthesis firmly into the intended placement and wait about 5 minutes for the adhesive to dry naturally.
   * In the case of high humidity in summer, we recommend waiting for approximately 8 minutes.

3. Once you have confirmed that it is completely fixed, installation is complete.

How to remove

Gently remove the prosthesis little by little from the edge of the attachment area, being careful not to apply too much pressure.
Carefully remove any adhesive remaining on the prosthesis using the same method.

By being gentle to your skin and prosthesis, you can remove it correctly.

Wearable time

The amount of time you can wear the device varies from person to person, but it should not exceed a maximum of 24 hours.
If you plan to use the prosthesis for a long period of time, please remove it once, clean your skin and the prosthesis, and then wear it again.

How to care for your prosthesis

After fitting, be sure to use room temperature or lukewarm water and carefully wash off the adhesive and oils using body soap or hand soap, just as you would wash the prosthesis on a human body.
After rinsing thoroughly, gently wipe off any moisture with a soft cloth and allow the prosthesis to dry naturally before using it again.

Regarding urination

It is only possible to urinate using the standing type prosthesis.
Standing urination type prostheses allow you to urinate while standing.

LUY 's standing urination prosthesis allows urination to occur in a natural way and can be used without feeling any discomfort in daily life.
If you have any questions about the care and wearing of your prosthesis, please feel free to ask us.

▼Click here for the Epithesis Standing Pee Series
https://luy3588.com/collections/ftm01